Saw Trax DAS Dual Arm Saw

More Views

Saw Trax DAS Dual Arm Saw


Make more cuts in less time. Saw Trax has taken the Makita Beam Saw, removed the shoe, and built a saw carriage around it. This carriage has a 3 point hold down that locks the saw in place. This rock solid design gives you blade stability and easy saw blade replacement with either a 16"" blade or a 16-5/16"" blade. Depth of cut remains at 6"" with either blade. With every cut you make with a radial arm saw, you leave some dust against the fence. This dust can throw off the alignment of your material, especially when it accumulates on the table. To make accurate cuts every time, you need to clean the dust every time. This cleaning takes a lot of time. This Dual Arm Saw has the Dust Buster Fence System that creates a gap between the top of the material and the bottom of the fence where saw dust can accumulate. The cut is not affected. On the table in this gap created by the fences there are dust ports. These ports along with the blade slot in the table evacuate the dust away. With our machine you can make more accurate cuts in less time than with other machines because you don't have to sweep the dust away.
  • Saw Blade Size: 16"" or 16-5/16"", 1"" Arbor
  • Voltage: 110V
  • Amps: 15
  • No Load Speed: 2200 RPM
  • Depth of Cut: 6""
  • Crosscut Capacity on 1.25"" thick material: 32""
  • Crosscut Capacity on 6"" thick material: 28""
  • Table Size: 36.5"" x 60.5""
Additional Information

Additional Information